Flamingo nXt

easy rendering for Rhino in Windows

Is there a way to "trim" the Ground Plane? I am making a render of a boat that has an area in the stern that is lower than the ground plane. As a result it looks flooded! Any suggestions?

Views: 132

Reply to This

Replies to This Discussion

Get a Bucket?   

No but seriously, My suggestion would be to create a huge surface and trim it with your boat, Using that surface as the new ground plane.  But there are probably better ways of doing it,  Good Luck

Btw, Nice boat design.

Thanks... I thought about doing that... haven't tried to 'model' the water as yet... but was hoping to avoid having to do so....

In the end I made a surface... it was all very simple... though I did note that it took a lot longer to do the renders as a result...



© 2018   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service