Flamingo nXt

easy rendering for Rhino in Windows

Once my file has around 20 materials I run into the problem of Materials swapping or replacing each other through out my whole file. For example I have a good amount of material files used in my model. Then i go to add a new material (aluminum polished). the new material either wont apply to the object or replaces another material.

When i open the flamingo nxt materials browser and try to apply the "new aluminum polished" it thinks that material is something else like glass smooth. Even though that new material is now in the "Materials in Model" section. If i try to re-add the material it ask do i want to replace it i say yes. But instead it just makes a duplicate of the material it thinks it is in this case the glass smooth, but calls it "aluminum polished-00"

has anyone run into this issue its truly annoying and has been in the program since the release of flamingo nxt. is this being resolved?

Views: 199

Reply to This

Replies to This Discussion

This is a problem with an earlier version of Rhino 5.  It messed up material IDs.  Here is what you need to do:

  1. Make sure RHino 5 is SR10 or SR11 (Rhino Help pulldown > About Rhinoceros)
  2. Make sure you have the newest Flamingo NXT.
  3. Files that are messed up will need to have material reassigned.  But if you have the newest Rhino, you will not see the problem again.

Does this help?



© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service