easy rendering for Rhino in Windows
Flamingo nXt running slowly
Hi there,
Just after some thoughts, I have been running the commercial nXt with Bongo, some models run fine others run dead slow. Has anyone else had the same problem, really frustrated.
Ran the model, quite a long sequence, not a problem (large model 250mb plus), 750 frames, 6 passes, 8 hours. I have just used the same model but animating a different part, 300 frames, only 2 passes 12 plus hours. I have even deleted whole section of the model so only 98mb to see if that will help.
I was unsure if it was nXt, Bongo or R5, so when this happened before some point last week, I ran the slow sequence with Rhino Render and it was fine. Based on that you can say the bottle neck was not Bongo, or R5 and relates to nXt.
Sadly I can't share the model, I know that does not help, hence thoughts and advice would be appreciated.
Running on 64 bit Windows 7, not the most powerful but works with the last model.
Thanks M
Replies to This Discussion
-
Permalink Reply by Scott Davidson on -
It is hard to tell. I would render an scene from the middle of the animation and see if one image is slow. There are a number of things that can affect performance, but we would need to look at a specific scene to figure out what that is.
-
Permalink Reply by Mash Derrick on -
I appreciate that, it is just the same file, worked really, then come back, few changes and bingo, it is like driving with the handbrake on.
Once it is finished I will strip it down to see what is happening, any tests could I do? I don't want to mess around with it mid progress.
Thanks M
© 2013 Created by Scott Davidson.
